PDS • User’s Guide 111
7. PDS-902 3G Enhancements
Output Display Modes
Figure 7-3. Program and Preview background selections
lìíéìí=aáëéä~ó=jçÇÉë
Three output display modes are available from the User Preference menu:
• Full Screen Mode
• PIP Mode
• Matrix Mode
At any time, you can switch between the different modes. You are prompted to confirm the
switch before proceeding.
cìää=pÅêÉÉå=jçÇÉ
Full screen mode is the main operating mode and the system default setting. In this mode,
the Program and Preview sources default to Input 1.
mfm=jçÇÉ
The PDS product line supports displaying one or two PIPs on Program. You can preview
and adjust the next PIP state on a Preview monitor. In PIP mode, the Preview output does
not display live images. Instead, it shows outlines where the PIPs are located, and each
PIP is labeled with the input number.
The front panel of the PDS provides a PIP1 button and a PIP2 button. Use these buttons to
User Preference
> Trans Time 1
Auto Acquire ON
Auto Input Cfg. OFF
Auto Input Save ON
Output Mode Fullscreen
Pgm Background Black
Pvw Background Black
Background Color >>
HDCP >>
Auto Take OFF
Menu Context OFF
Save System State
Note
After setting up custom configurations for the PDS, including
the system mode, input sizing and output adjustments, you
can save your settings by selecting Save System State on
the User Preference Menu. This selection is also available
on the System Menu, and is described in “Save System
State” on page 74.
