66 PDS • User’s Guide
4. Operation
Setup Menu
bíÜÉêåÉí
From the System Menu, select Ethernet to display the Ethernet Menu:
Figure 4-39. Ethernet Menu (sample)
The following Ethernet functions are available:
• DHCP — DHCP can be turned OFF or ON.
~ When OFF, the Config Network field appears, which enables you to
manually enter a static IP address, Subnet mask and Gateway.
~ When ON, the PDS queries the DHCP server for a valid IP address, and
the Config Network field is hidden.
• If the PDS finds a DHCP server and receives an IP address, the
address is displayed.
• If a server is not found, an IP address is not assigned. The
address display in the menu will be 000.000.000.000.
• Config Network — select this function to display the Config Network Menu,
which enables you to choose the specific Ethernet address you wish to change.
Figure 4-40. Config Network Menu (sample)
~ Select Set Static IP to display the Static IP Menu, which enables you to
set a static IP address when a DHCP server is not available. The editing
procedure is discussed below.
Figure 4-41. Static IP Menu (sample)
ETHERNET
> DHCP OFF
Config Network >>
Remote Control >>
IP 192.168.000.010
M 00:04:a5:19:10:52
Note
Always consult with your network administrator to obtain valid
IP, subnet mask and gateway addresses.
CONFIG NETWORK
> Set Static IP >>
Set Netmask >>
Set Gateway >>
STATIC IP
> 192.168.000.010
