PDS • User’s Guide 67
4. Operation
Setup Menu
~ Select Set Netmask to display the Netmask Menu, which enables you
to set a netmask. The editing procedure is discussed below.
Figure 4-42. Netmask Menu (sample)
~ Select Set Gateway to display the Gateway Menu, which enables you to
set a gateway. The editing procedure is discussed below.
Figure 4-43. Gateway Menu (sample)
Use the following steps to edit the IP address, Netmask or Gateway. Valid
fields range from 000 to 255.
a. Press SEL to begin editing. This action highlights the first digit, and
displays the carat “^.”
b. Use the ADJUST knob to move the carat left and right through the
address.
c. When the desired digit is highlighted, press SEL to edit the value. The
carat changes to the pound sign “#.”
d. Use the ADJUST knob to select the desired value (0 - 9).
e. Once the value is selected, press SEL to “accept” the new value. The
pound sign “#” changes back to the carat “^.”
f. Repeat the process from step b for all additional digits that you wish to
change.
g. When complete, press ESC to display the Apply Changes Menu.
•Select Yes (SEL) to apply all changes.
•Select No (ESC) to exit the procedure without saving changes.
In each case, system returns to the root menu.
When Ethernet setup is complete, you can communicate with the PDS via the
Ethernet port.
~ In Appendix B, refer to the “Remote Commands” section on page 139
for details on communicating with the PDS via Telnet.
~ In Chapter 5, refer to the “GUI Connection and Launch” section on
page 88 for details on running the web-based GUI.
Netmask
> 255.255.255.000
Gateway
> 192.168.000.002
