72 PDS • User’s Guide
4. Operation
Setup Menu
3. Press SEL. The confirmation message shown in the following illustration appears:
Figure 4-52. Executive Mode Confirmation Message
4. Press an input button or LOGO.
The button will blink slow to indicate that the input is ready to be taken to Program.
The input source signal automatically goes to Program without requiring a Take,
regardless of your Auto Take setting.
5. To disable the front panel Executive lockout mode, press and hold the SEL and
ESC buttons simultaneously for 3 seconds. When the button combination is
detected, the system returns to the menu that was displayed before Executive
lockout mode was enabled.
cáäÉ=^ëëçÅá~íáçå
From the System Menu, select File Association to display the File Association Menu,
which enables you to select or change a configuration file for each of nine physical inputs
(1 through 8 and SDI). The configuration file contains settings that govern everything from
pixel resolution to aspect ratio and color balance — any setting you can change using the
Input Menu. The PDS can store up to 64 input configuration files in non-volatile memory.
Each time you press an input button, the PDS uses the configuration file associated with
that input. The file is designated by a number from 1 to 64. The default file for each input is
the same as the input number—Input 1 uses configuration file 1, and so on. The default file
for the SDI input is 9.
You can view and change the current setting for each input by using the File Association
Menu, shown in the following illustration:
Figure 4-53. File Association Menu (sample)
When you associate a configuration file with a specific input, the file is used by any input
source connected to that input.
Executive Mode
Enabled
File Association
> Input 1 1
Input 2 2
Input 3 3
Input 4 4
Input 5 5
Input 6 6
Input 7 7
Input 8 8
SDI 9
