74 PDS • User’s Guide
4. Operation
Setup Menu
If you suspect a problem with the PDS, press SEL to run a series of internal diagnostic
tests. The menu will report back “PASS” or “FAIL.”
p~îÉ=póëíÉã=pí~íÉ
From the System Menu, select Save Config to save all current “system” settings so that
they may be restored at power up. A message is briefly shown, after which the PDS returns
to the System Menu.
Figure 4-57. Saving System Configuration Message
Please note the following important points regarding the system configuration file:
• When you perform the Save Config function, all configuration parameters from
the System Menu are saved in non-volatile memory. If you do not perform the
function, data will not be restored upon the next system power up sequence.
• This command also saves the current input as the default power-up selection.
• If you do not perform the Save System State function, data will not be restored
upon the next system power up sequence.
• If you make a change in the System Menu and attempt to exit the menu (by
pressing ESC) without saving changes, the system displays the following prompt::
Figure 4-58. Save System Configuration Prompt
~ Select Yes (SEL) to save changes.
~ Select No (ESC) to continue operation without saving the changes.
Note
If the menu reports “FAIL,” contact Barco Customer Service.
In Appendix C, refer to the “Contact Information
” section on
page 174 for contact details.
Saving System Config...
Note
If you want the PDS to always power up and acquire an input
other than input 1, perform the Save System State command
while the desired input is selected on Program.
Save System Cfg?
<SEL> = Yes
<ESC> = No
