PDS • User’s Guide 81
4. Operation
Using the Logo
p~îáåÖ=~=içÖç
Use the following steps to capture and store a logo:
1. To capture and store a full-screen logo, first select the input that you wish to store,
and transition it to Program with a TAKE.
2. From the Setup Menu, select Logo to display the Logo Menu.
Figure 4-65. Logo Menu (sample)
3. In the Selection field, press SEL and choose the “register” into which you want to
save the logo (e.g., LOGO1, LOGO2 or LOGO3). Press SEL again.
4. Scroll to the Save Pgm to Logo field, and press SEL to save the input as a full-
screen logo.
5. Repeat steps 1 through 4 to save up to two additional logos.
qê~åëáíáçåáåÖ=íç=~=içÖç
To transition from the source on Program to a saved logo:
1. With an output source on Program, press the LOGO button. Please note:
~ If Menu Context is ON (in the User Preference Menu), the Logo Menu
automatically appears when the LOGO button is pressed.
~ If Menu Context is OFF, the Status Menu (or the current menu) remains
on when the LOGO button is pressed.
The LOGO button blinks “slow” to indicate that a logo is pending, and the Logo
Menu appears:
Figure 4-66. Logo Menu — Selecting a Logo
LOGO
> Selection LOGO1
[EMPTY]
Save Pgm to Logo
Note
When a logo is pending or already on Program, the Save
Pgm to Logo field does not appear.
Important
When a “protected” HDCP source is selected (inputs 5
through 8), you cannot save a logo.
LOGO
> Selection LOGO1
[1024x768]
