Filter
Top Products
Microphones · Headphones · Wireless Microphones · Wireless Headphones · Headsets · Electroacoustical Components
Limited Warranty
Valid only in the United States. AKG Acoustics warrants AKG products against defects in material
or workmanship for a period of two years from the date of original purchase for use, and agrees to
repair or, at our option, replace any defective unit without charge for either parts or labor. Important:
This warranty does not cover damage resulting from accident, misuse or abuse, lack of reasonable
care, the affixing of any attachment not provided with the product, loss of parts or connecting the
product to any but the specified receptacles. This warranty is void unless service or repairs are
performed by an authorized service center. No responsibility is assumed for any special, incidental
or consequential damages. However, the limitation of any right or remedy shall not be effective
where such is prohibited or restricted by law. Simply take or ship your AKG product prepaid to our
service department. Be sure to include your sales slip as proof of purchase date. (We will not repair
transit damage under the no-charge terms of this warranty.) Note: No other warranty, written or oral
is authorized by AKG Acoustics, Inc. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state. Some states do not allow the exclusion or
limitation of incidental or consequential damages or limitation on how long an implied warranty
lasts, so the above exclusions and limitation may not apply to you.
Specifications subject to change without notice.
AKG Acoustics GmbH
Lemböckgasse 21–25, P.O.B. 158, A-1230
Vienna/AUSTRIA
Tel: (43 1) 86 654-0*, Fax: (43 1) 86 654-516
Internet: http://www.akg.com
AKG Acoustics; A Division of Harman Pro Germany
Bodenseestraße 228, D-81243 München/GERMANY
Tel: (089) 87 16-0, Fax: (089) 8716-200
Arbiter Pro Audio
Wilberforce Road, London NW9 6AX/ENGLAND
Tel: (0181) 202 1199, Fax: (0181) 202 7076
AKG ACOUSTICS, U.S.
914 Airpark Center Drive
Nashville, TN 37217, U.S.A.
Tel: (615) 620-3800, Fax: (615) 620-3875
Studer Japan Ltd.
2-43-7, Uehara, Shibuya-ku, Tokyo 151-0064/JAPAN
Tel: (813) 3465-2211, Fax: (813) 3465-2214
Erikson Pro Audio
620 McCaffrey, St-Laurent, Quebec, H4T 1N1, CANADA
Tel: (514) 738-3000, Fax: (514) 737-5069
Internet: www.jam-ind.com/eriksonpro
AKG is constantly improving and modifying its products, therefore, specifications are subject to change without notice.
The microphone shall be of the boundary layer type suitable for
temporary or permanent mounting on flat surfaces.
The microphone shall have a flat circular profile, with the
condenser element mounted in the middle. The transducing
element shall communicate directly to the outside through small
openings. The sensitivity of the microphone shall be at least
20 mV/Pa when mounted on a boundary 4.95 feet (1.5 meters) on
a side, and the frequency range shall extend from 20 Hz to 20 kHz.
The response shall exhibit an average rise of 6 dB in the range
from 5 kHz to 15 kHz to compensate for losses normally
encountered in the operation of boundary layer microphones in the
transition region between direct and reverberant fields. The self
noise level of the microphone shall be no greater than
16 dB, as measured with A-weighting, and the total harmonic
distortion shall be no greater than 1% at operating levels of
130 dB-SPL. The microphone shall accept phantom powering over
the range from 9 to 52 volts. The microphone shall be the AKG
Acoustics Model C 562 BL.
Graphical Data
Architects and Engineers Specifications
DS-C 562 BL
On-axis Frequency
Response (measured at 1 meter)
Polar Response