Filter
Top Products
2
DIAGRAM AND PARTS DESCRIPTION
1. Microphone 1 Balanced
Input with Gain Control
(1/4” or XLR): This jack can
take either a ¼” balanced or
a XLR balanced cable.
2. Instrument/Microphone 2
Input with Gain Control
(1/4”): This mono input
accepts a ¼” input such as a
microphone, guitar, or other
musical instrument.
3. iPod/Auxiliary input with
Gain Control (Stereo
RCA): This stereo RCA
input can be used to connect a CD, MP3, or other audio source. The knob controls the level of the iPod and
the RCA input. To connect to a portable device with a 1/8” headphone jack, you need a standard 1/8”-to-RCA
adapter which is not included.
4. Master Volume Control: This knob controls the master volume of the TransActive Live.
5. iPod Charging Switch: Turn on iPod charging by setting this switch to the "Charge iPod" position.
6. Battery Level Indicator: While the unit is powered ON, these four lights indicate the power left in the battery.
Battery life varies based on volume and usage.
7. Link Output: Connect a 1/4" stereo (TRS) cable to this line-level output to connect another amplification
device, such as another TransActive Live.
8. Power In (IEC): Insert the included power cable here to charge the unit. Note that the TransActive Live can
run off wall power while it simultaneously charges the battery. The charge indicator illuminates when the
battery is charging.
9. Voltage Selector*: Set this to the correct voltage for your
location's standard.
10. Power ON/OFF Switch: Turns TransActive Live on or off.
Please note that while TransActive Live is connected to a
power source, it does not need to be powered on to
charge the battery.
IMPORTANT NOTES
If your sound is distorted at high volumes, please refer to the following troubleshooting scenarios:
• Input is clipping: Try lowering the input gain or the volume control on your sound source or music instrument.
• Output is clipping: Lower the main volume level.
• There is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass level.
This will allow you to play the music louder before clipping (distortion) occurs.
• The link cable: is being plugged into the instrument or MIC input instead of the RCA line input.
Important: With all speakers, an initial “break-in” period is needed to perform at optimal levels. To properly “break-
in” your TransActive Live, play an audio source at medium volume for a few hours.
SPECIFICATIONS
Input Voltage: AC 100-120 V / 60 Hz, 220-240 V / 50 Hz
Output Wattage: 16 W (THD: < 1%)
Frequency Response: Aux Input: 78 Hz – 20 kHz
iPod Input: 63 Hz – 20 kHz
Time required to fully charge the TransActive Live: ~ 6 hrs.
Battery life: 12 hrs. with typical use
10
8
9
5
6
7
1
324
* Note: Battery life may vary
based on temperature, age,
and volume usage of product.
* WARNING: U.S. users should set this
switch to "100-120V" whereas U.K. and most
European users should set this to "220-
240V."Selecting the improper voltage can
damage the unit.