Filter
Top Products
10
14
-. +4dBu/-10dBV Switch
Your AMX-120 provides the gain select switch, which is used to adjust the sensitivity of line input on stereo channels.
Line level are considered to be between 1V and 2V RMS (+2dBu ~ +8dBu) in professional equipment, peak levels
may extend to over 10V RMS (+22dBu). The accepted standard for sound reinforcement equipment is +4dBu.
Unfortunately, many low budget components fall short of these levels, so we need to "baby" their level, and find an-
other source for the signal strength necessary to drive the power amplifiers, in such situations, the -10dBV operating
level is compromised.
NOTE: The remaining controls of stereo channel are the same as in the mono channel section.
MAX
-
8
2TKTO
CTRL ROOM
2TKTO MIX
TAPE
0
PHONES
-+15
8
0
AUXSENDS
-
8
2TKIN
MAX
0
+5
-20
PH
PWR
CLIP
OUTPUT LEVEL
+15
-
8
MAIN MIX LEVEL
/
CTRL ROOM
R
L
4.3 MASTER Section
-. MAIN MIX LEVEL Dial
This control sets the amount of signal sent either
to the main out socket or to the tape output.
15
-. OUTPUT LEVEL LED Display
This stereo 4 segments LED meter will indicate
the level of the overall output signal.
16
-. POWER LED
This LED indicates when the power is on in your
AMX-120.
17
-. PHANTOM LED
This LED indicates when the phantom power is
switched on.
18
-. 2TK IN Control
This control is used to adjust the level of 2TK IN signal, which can be varied from - to MAX.
21
-. AUX SENDS Control
22
This control is used to determine the master AUX SEND levels, which can be varied from - to +15dB.
-. 2TK TO CTRL ROOM Switch
19
Engaging this button to route the 2 TRACK IN signal
into the control room output.
-. 2TK TO MIX Switch
20
Engaging this button to route the 2 TRACK IN signal
into the main output.
15
16
17
18
19
20
21
22
23