Filter
Top Products
American DJ would like to thank for your purchase of this great
product. For those of you that are to impatient to read the entire
user manual we have compiled these quick start instructions. We
hope that you will at least read through these instructions to famil-
iarize yourself with the basic understanding of the unit. The Q-221
is part of American DJ’s continuing evolution in audio technology.
This unit has been built and designed with the typical DJ in mind,
by DJ’s. We have attempted to provide you with the most reliable
product on the market by using only components made from qual-
ity products.
MASTER LEVEL - Use this level control to set your volume
output. Try never to send an output of more than +4dB to your
system. Signal at levels higher than this will start to distort and may
cause damage to your system and speakers. Remember that a
distorted signal from you mixer will only be multiplied throughout
your system.
CHANNEL TRIM LEVEL - The channel trim levels are not to be used as volume controls, never
use the channel trim to set the output volume. These controls are used to aid in distortion control. Use
these control to preset your signal level before the crossfader. With your channel faders in the maximum
position, use the channel trim level to set an average output level of about +4dB on you master level
meter.
HEADPHONES - To avoid sever hearing damage , always be sure the headphone level is set to
minimum before plugging them in. Never put the headphone on without making sure the headphone
level is turned down.
DJ MIC - The main mic connector uses a 1/4” jack unbalanced connector.The DJ mic has an indepen-
dent volume control. When feedback occurs when using the mic, try lowering the “low” level this may
reduce the feedback. Always leave the mic level to it’s minimum level when not in use.
PHONO/AUX SWITCH (24) - This switch is used to change the selected input from phono level to
line level and vice versa. Channels 1 and 2 may be switched PHONO/AUX or LINE. The selectors for
AUX1/PHONO1 and AUX2/PHONO2 are on the rear panel (24).
Q-START FEATURE - This function works in conjunction with a compatible American DJ “Q”Start
CD player. When used with a compatible CD player, you can use the crossfader to start and stop the
CD Player with the slide of the fader. The ON/OFF “Q ”START switch activates this FADER “Q ”START
feature.
Q-221™ QUICK START INSTRUCTIONS
©American Audio® - www.americandj.com - Q-221™ Instruction Manual Page 4