Filter
Top Products
Q-FX19™ CONTROLS AND FUNCTIONS cont.
©American Audio® - www.americanaudio.us - Q-FX19™ Instruction Manual Page 15
a power cord when the ground prong has been removed or broken off. The ground prong is used to
reduce the risk of electrical shock in case of an electrical short. This cord is designed to fit in one
direction only. Do not attempt to force a cord if it does not fit, be sure the cord is being inserted
properly.
Q-FX19™ DSP EFFECT CONTROLS AND FUNCTIONS
60
73
72
71
70
69
68 67 66 65
64
63
62
61
76
77
78
79
58
57
56
59
74
75
+
56. CUE LEVEL DISPLAY - This display measures the incoming source signal into a channel. This
measurment will directly reflect the channel(s) with the PFL function enguaged.
57. CHANNEL OUTPUT LEVEL INDICATOR - The indicators are used to measure
incoming signal
levels. Use this indicator to visually maintain an average signal output of +4dB. A consistent average
output level of +4dB will produce a clean output signal.
58. INPUT INDICATOR - These indicators are used to give a visual representation of the effect input
selector (68). Notice: When Mic 1+2 is selected, both Mic 1 and Mic 2 will glow in the display.
59. EFFECTS INDICATOR - When any of the eight effects are in use, these indicators will glow to
match any of the eight effects that may be functioning.
60. DELAY/PHASE BUTTON - This button is used to activate and deactivate either the DELAY or
PHASE effect. When the DELAY effect is activated the DELAY/PHASE BUTTON will glow green, when
the PHASE effect is selected the button will glow red. The DELAY effect repeats the sound that was