Filter
Top Products
Q-SPAND PRO FRONT PANEL - CONTROLS AND FUNCTIONS CONT.
28. FEATHER FADER PLUS CROSSFADER - This fader is used to blend the output signals of chan-
nels one and two together. When the fader is in the full left position (channel 1), the output signal of
channel one will be controlled by the master volume level. The same fundamentals will apply for chan
-
nel two. Sliding the fader from one position to another will vary the output signals of channels one
and two respectively. When the crossfader is set in the center position, the output signals of both the
channels one and channels two will be even.
29. CROSSFADER CURVE ADJUSTMENT - This rotary knob is used to change the way the cross-
fader will operate. The crossfader can operate in different modes, “NORMAL CURVE”, “QUICK CURVE”
or any variation of the two. (Quick Curve usually used for scratching).
30
. MIC 2 VOLUME CONTROL - This knob controls the output volume of MICROPHONE 2 (34).
However, master volume is controlled by the MASTER VOLUME CONTROL (22).
31
. MIC 1 VOLUME CONTROL - This knob controls the output volume of MICROPHONE 1 (3).
However, master volume is controlled by the MASTER VOLUME CONTROL (22).
©American Audio® - www.americanaudio.us - Q-SPAND PRO Instruction Manual Page 12