Filter
Top Products
Inputs:
Microphone 1.5mV, 600 Ohm
Phono 1.2mV, 47kOhm
Line 100mV, 27kOhm
Output 20V, peak to peak
Frequency range 20Hz-20KHz, ± 1dB
Distortion <0,03%
S/N-ratio >85dB
Talkover -15dB
Tone control Treble: 10Khz ± 12dB
Middle: 1 KHz ± 12dB
Bass: 100 Hz ± 12dB
Headphone impedance 16 Ohms
Power supply AC115/230V, 50/60Hz
Dimensions 12.5” W x 10.25” D x 4” H
262 x 320 x 102 mm
Weight 8 lbs. / 3.5 kg
© American DJ® AUDIO Los Angeles, CA 90058 USA
Specifications subject to change without notice. XDM-343 User Instructions page 5
Replacing the Crossfader
Technical Specifications - model XDM-343
Instructions for replacing the crossfader:
• Disconnect from main power supply
• Remove the fader knob.
• Remove the two outer screws.
• Take the fader out and unplug the connection cable.
• Connect the new fader and replace back into mixer.
(28) MIC 2 JACK - Connect your microphone with 1/4 inch (6.3mm) jack plug here. The signals can be controlled via
CHANNEL 2, if the PHONO / LINE / MIC switch (5) is set to MIC 2.
(29) LINE 3 - PHONO 3 SELECTOR - Used to switch the CH-3 input jacks to line 3 or phono 3.