Filter
Top Products
When you have finished using the CD player, before switching off the power be sure that the disc holder has
been closed with the OPEN/CLOSE button (Figure 15).
CAUTION: Do not forcibly close the disc tray when the power is off.
Do not switch off the power when
the disc holder is open.
Switch off the power after the disc holder has
been closed with the OPEN/CLOSE button.
1. Precautions on handling compact discs
• Do not allow fingerprints, oil or dust to get
on the surface of the disc. If the disc is
dirty, wipe it off with a soft dry cloth.
• Do not use benzene, thinner, water, record
spray, electrostatic-proof chemicals, or
silicone-treated cloths to clean discs.
• Always handle discs carefully to prevent
damaging the surface; in particular when
removing a disc from its case or returning it.
• Do not bend the disc.
• Do not apply heat.
• Do not enlarge the hole in the center of the
disc.
• Do not write on the label (printed side) with
a hard-tipped implement such as a pencil
or ball point pen.
• Condensation will form if a disc is brought
into a warm area from a colder one, such as
outdoors in winter. Do not attempt to dry`
the disc with a hair dryer, etc.
2. Precaution on storage
• After playing a disc, always unload it from
player.
• Always store the compact disc in the jewel
case, protecting from dirt or damage.
• Do not place discs in the following areas:
a) Areas exposed to direct sunlight for a
considerable time.
b) Areas subject to accumulation of dust or
high humidity.
c) Areas affected by heat from indoor heaters,
etc.
REV 3/01
BEFORE SWITCHING OFF THE POWER
COMPACT DISCS
Fig. 15
American DJ® AUDIO • DCD-PRO200MKIII™ INSTRUCTIONS MANUAL • PAGE 13
BASIC OPERATION (CONT.)
13. Loop Play
• Press the LOOP button to set the loop start point A, the LOOP indicator will flash on the LCD.
• Press the LOOP button again to set the loop end point B. After the B point is set the playback will
enter the loop play from A to B repeatedly.
• Press the LOOP button again, the loop play function is canceled, the LOOP indicator goes out.