Filter
Top Products
Due to fog residue, smoke, and dust, cleaning the internal and external
optical lenses must be carried out periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside
casing.
2. Use a brush to wipe down the fan grill.
3. Clean the external optics with glass cleaner and a soft cloth every
20 days. Situation may very. If used heavily in clubs with lots of
fog, cleaning may be required more often.
4. Clean the internal optics with glass cleaner and a soft cloth every
30-60 days.
5. Always be sure to dry all parts completely before plugging the
unit in.
Cleaning frequency depends on the environment in which the fixture
operates (i.e. smoke, fog residue, dust, dew).
©American DJ Supply® - www.americandj.com - DJ Roller™ Instruction Manual Page 10©American DJ Supply® - www.americandj.com - DJ Roller™ Instruction Manual Page 9
DJ Roller™ Cleaning
DJ Roller™ Lamp & Fuse Replacement
Always replace with the exact same type lamp and fuse, unless
otherwise specifi ed by an authorized American DJ
® service tech-
nician.
Caution: Always disconnect the units main power before performing
any type of service or fuse replacement! Always disconnect the main
power before attempting to replace the lamp.
Lamp Replacement:
1. Be sure to follow proper procedures when handling halogen lamps.
2. Lamp replacement has been made simple by incorporating the use
of a removable lamp tray and thumb screws.
3. Loosen the thumb screw on rear cover.
4. Remove the tray.
5. Remove and replace the bulb.
6. Reassemble.
Fuse Replacement: To replace the protective fuse, use a fl at head
screwdriver to unscrew and remove the fuse holder. Gently remove
the old fuse and replace it with a new one. Insert the fuse holder back
into the fuse housing and tighten.
For any other service related issues, please contact American DJ
®
customer support.
The DJ Roller™ may be controlled by a wide range of controllers such
as the American DJ
® Show Designer,™ or DMX Operator.™ A basic
blackout controller (MINI/C) may also be used with the DJ Roller.™
MINI/C features:
DJ Roller™ Optional Remote
The MINI/C controller may be purchased separately allowing you to
control the main unit, and any others connected to it, while it is in
stand alone mode. You can set the unit to blackout. If you have more
than one unit, make sure the remote control is plugged into the first
unit in the daisy chain. The remote control will not have any effect if
the unit is in DMX mode. When the unit is in blackout mode, the light
will come on next to the blackout button.
30 ft. cable
Stand-By (Blackout)