Filter
Top Products
part of American DJ’s new
ccoommmmeerrcciiaall sseerriieess
fog machines with patented Electronic
Thermo Sensing (E.T.S.), for continuous heating regulation.
FFuunnccttiioonnss::
The new Commercial Series MASTER BLASTER™ fog machines all come with E.T.S., for
continuous heating-regulation. These foggers also carry a new innovation in fog machine
technology, user cleanable heaters. The MASTER BLASTER ™ operates via a 25 ft. wired,
timer remote control, that comes mounted into the unit. The remote may be removed, by
unscrewing the four (4) thumb screws that hold it to the base. The unit also contains a
removable, one quart reservoir.
EElleeccttrroonniicc TThheerrmmoo SSeennssiinngg // EE..TT..SS..::
This feature allows you to have fog output available at almost any time. A small on board
micro processor constantly monitors the operating temperature of the fog machine. When
the fog machine drops ONE (1) degree in temperature the E.T.S., automatically senses this
change and turns the heater on to raise the temperature that one degree lost. This enables
the end user to have fog output at anytime. The only time fog will not be available, is at the
end of the machines duty cycle (The fog output was maxed out and the heater has to
reheat completely).
OOppeerraattiinngg aanndd RReemmoottee IInnssttrruuccttiioonnss::
Plug your fog machine into a standard 110V/120V supply. The remote control comes con-
nected to the fog machine but can be removed to access the 25ft. cord. Make sure there is
an adequate supply of American Fog Juice™ in the fluid reservoir. Running the fog machine
dry will cause pump failure and or clogging. This is the largest cause of failure in fog
machines. Only American Fog Juice™ is recommended and not all fog juice is created
equal. Once the machine is plugged in and turned on, a red L.E.D. will indicate the unit is
receiving power. The unit has a warm up time of five (5) minutes. After the unit has warmed
up, a GREEN L.E.D on the remote will light indicating the unit is ready to emit fog. To emit
fog, simply press the green button on the remote for desired length of time. If the GREEN
L.E.D. is on and fog does not come out after holding the button down for 30 seconds, check
the fluid tank and hose to make sure there is fluid going through the hose. You can also
operate the fog output automatically by adjusting the timer settings on the remote.
The remote has three (3) L.E.D.s that indicate different functions; The YELLOW L.E.D. will indi-
cated the timer is turned on and is activated. The RED L.E.D. indicates power is on. The
GREEN L.E.D. indicates fog output is available. The remote also contains two rotary knobs.
The Duration knob serves two functions 1) Turns the timer on and off. 2) Sets the timers dura-
tion (Length of fog output). The interval knob sets the amount of time in between fog out-
put from 30 seconds to 10 minutes.
CCaauuttiioonn:: BBeeffoorree rreemmoovviinngg oorr rreeppllaacciinngg tthhee rreemmoottee uunniitt ddiissccoonnnneecctt tthhee ppoowweerr ssuuppppllyy..
Affordable Quality Lighting Products from American DJ Supply, Inc. Los Angeles, CA. 90058 Page 2