Filter
Top Products
American DJ
®
LOS ANGELES, CA. 90058 USA - SNAP SHOT DMX/D PG.3
DMX Function
DMX Data Assignments
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
on
on
on
on
on
on
on
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
on
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10 1 2 3 4 5 6 7 8 9 10
Intensity is first
DMX byte
Intensity is first
DMX byte
Intensity is first
DMX byte
Intensity is first
DMX byte
Intensity is
preset
Intensity is
preset
Intensity is
preset
Duration is
1/2 cycle
Duration is first
DMX byte*
Duration is second
DMX byte*
Duration is
1/2 cycle
Duration is
1/2 cycle
Duration is first
DMX byte*
Duration is second
DMX byte*
Rate is set by DMX
refresh**
Rate is set by DMX
refresh**
Rate is set by DMX
refresh**
Rate is first DMX
byte
Rate is second DMX
byte
Rate is third DMX
byte
Rate is second DMX
byte
Intensity from DMX Values from 0 to 255 are useable
Values from 0-255 are useable Values 0
will flash the lamp for approx. 2 milliseconds,
Duration byte from DMX 255 will flash lamp for 5 seconds on AC 230V
50 Hz supply; On a 120 AC line with ,value 0
will last 3 milliseconds, value 255, 4 seconds.
Values from 0-255 are useable Values 0
will flash the lamp every 4 seconds
Rate byte from DMX on AC 230V 50 Hz supply; On a
120 AC line with Value 0
will flash every 6 seconds.On a 120 AC line
with transformer. The highest rate is 50 or 60
flashes per second
DMX MODE
Using the 1 thru 3 mode dipswitches you can control the intensity, duration, rate by
DMX in 7 different ways with a DMX-512 Board. The following table show how the various
settings these dip switches effect the way the DMX data should be sent.
* By setting duration for a long enough period, latch on is possible
** Performance of Strobes will depend heavily on the intelligence and versatility of the DMX board when
rate is set by the DMX refresh. Higher rates can be achieved if smaller data packets are sent more often.
For modes that use only 1 DMX channel, units should be addressed sequentially
For modes that use 2 DMX channels, units should be addressed at every other address
For modes that use only 3 DMX channel,units should be addressed at every 3rd address
USED WITH
SS-DMX/19C