Filter
Top Products
T4™ Operating Instructions
©American DJ Supply® - www.americandj.com - T4™ Instruction Manual Page 3
Features:
The T4™ is a 4 channel chaser. The T4™ can be set to run in audio
or chase mode. The audio mode will trigger the chase pattern to the
rhythm of the beat. Chase mode will chase without requiring an audio
signal. The T4™ is deigned to run par cans, pin spots, and other small
fixture. You may draw a total of 6.3
A from the controller. Each channel
can draw up to 5A per a channel. Plug your fixtures into the Edison
sockets on the sides of the T4.™ After plugging your fixtures into the
T4™ plug the T4™ into a standard grounded wall outlet. Select your
operation mode and turn the T4™ on. Remember that if you select
the audio operation mode the T4™ will not chase until it receives an
audio signal.
T4™ Operating Modes
Slow:
When the Mode switch is in the “SLOW” position the unit will chase
(step from one to channel to the next) at a slow pace.
Normal:
When the Mode switch is in the “NORMAL” position the unit will chase
at a regular pace.
Audio:
When in the “AUDIO” mode each chase step will be regulated by
low frequencies heard through the built-in microphone.Turning the
speed knob down completely (counter-clockwise) in audio mode will
regulate the chase solely by low frequencies heard through the built-in
microphone. The audio sensitivity is preset by the manufacture and
may be adjusted.
T4™ Warranty Card
The T4™ carries a 90 day limited warranty. We recommend you fill
out the enclosed warranty card to validate your purchase. All returned
service items whether under warranty or not, must be freight pre-paid
and accompany a return authorization (R.A.) number. If the unit is
under warranty, you must provide a copy of your proof of purchase
invoice. Please contact American DJ
® customer support for a R.A.
number.
T4™ Controls & Functions
1. 3-POLE ELECTRICAL OUTLETS -
These are standard Edison 3-pole grounded electrical outlets.
2. INTERNAL MICROPHONE -
The T4™ comes equipped with a built-in microphone to pick-up the
beat of the music. This is used to trigger the controller in the audio
mode. The internal microphone will have no function when chase
mode is selected.
3. MODE SELECTOR SWITCH -
This switch is used to select any of the three operating modes; Slow,
Normal, or Audio.
4. LED INDICATORS -
The four channel LED’s will also glow to indicate channel activity.
5. SPEED ADJUSTMENT KNOB -
The T4™ uses a speed control knob to adjust the chase rate of the
built in program. Turning the speed knob in a clockwise direction will
increase the chase rate, turning the speed knob in a counter-clockwise
direction will decrease the chase rate.
©American DJ Supply® - www.americandj.com - T4™ Instruction Manual Page 4
®
TM
SPEED
FastSlow
Monitor
1234
Mic
Normal AudioSlow
American DJ
15432