Ampeg PF-210HE Musical Instrument Amplifier User Manual


  Open as PDF
of 4
 
PF-115HE / PF-210HE Speaker Cabinet
3
HIGH
FREQUENCY
ATTENUATOR
FULL RANGE
INPUTS
OFF
–6
0
IMPEDANCE: 8 OHMS
POWER: 400W RMS
PF-xxxHE
12
Rear Panel Connector Plate
System Block Diagrams
1. 1/4" TS Full Range Input / Output Jacks:Thejackplatefeaturestwo1/4"jackswired
inparallel,allowingeasydaisy-chainingfromonespeakertoanother.Eachofthejacks
may be used as an input or a through connection.
Connectthespeaker-leveloutputofyouramplifiertothecabinet’sinputjackusingagood
quality(non-shielded)speakercable(included).Never use (shielded) instrument cable to
connect speakers to an amplifier.
Youcanutilizetheunusedjackasanoutput/throughjacktoconnectasecond8ohm
speakercabinetinparallel.Thiswillpresentatotalloadof4ohmstotheamplifier.
2. High Frequency Horn Level Switch:Thethree-positionHFHornswitchallowsfor:
•Fullhighfrequencyoutput(0setting)
•Highfrequenciesreducedby6dB(–6setting)
•Hornshutoff(offsetting)
PF-115HE
PF-210HE
–
15" EMINENCE
8 OHM SPEAKER
TWO
PARALLEL
JACKS
+
–
COMPRESSION
DRIVER
+
CROSS
OVER
10" EMINENCE
16 OHM SPEAKERS
TWO
PA RALLEL
JACKS
COMPRESSION
DRIVER
CROSS
OVER
 previous