Filter
Top Products
Heritage SVT-CL Bass Guitar Amplifier
6
12. STANDBY SWITCH: Use this switch to
turn the standby power on or off. Press
the top of the switch to turn the standby
on. The Standby mode allows the tubes
to warm or remain warm without high
voltage being applied to them. This
extends tube life. This switch should be
OFF when first turning the amplifier on.
Allow the unit to warm up for at least
20 seconds before switching to the ON
position. During short periods of
non-use, the amp should be put into
Standby mode.
14. IEC POWER INPUT CONNECTOR: This
is where you connect the supplied AC
power cord. Plug the male end of the
cord into a grounded AC outlet.
DO NOT DEFEAT THE GROUND PRONG
OF THE AC PLUG!
The Front Panel continued
13. POWER SWITCH: Use this switch to
turn the overall system power on or off.
Press the top of the switch to turn on
the power. The power switch should be
engaged prior to the standby switch (as
mentioned to the left, #12). This switch
must be turned off to reset the amp
after a Fault condition.
1
2
3
4
hi
lo
ultra hi / lo
5
master standby
standby/
power/
fault
powertreblefrequencymidrangebassgain
-15dB0dB
1
2
3
4
hi
lo
ultra hi / lo
5
master standby
standby/
power/
fault
powertreblefrequencymidrangebassgain
-15dB0dB
13121110987654321
13121110987654321
23222120191817161514
15. FUSE: This protects the unit from
damage due to overload conditions or
power line surges. If the fuse blows,
replace it only with the same size and
type.
The Rear Panel