Filter
Top Products
Page - 10 Operator Manual – MX-206 Mixer
Copyright© 2006 – Ashly Audio Inc.
Specifications
SPECIFICATION
MX-206
DISTORTION
THD at +20 dBu, 20Hz-20KHz, input switch at -40dB
<0.05%
IMD (SMPTE) at +20dBu, input switch at -40dB
<0.02%
HUM & NOISE (20Hz-20KHz , input switch at -60dB)
Equivalent input hum and noise
<-127dBu
Residual output noise, TRS outputs, all levels at minimum
<-100dBu
Residual output noise, XLR outputs
<-90dBu
Master Level at nominal, all Ch. Level controls at min
<-84dBu
Master Level and one Ch. Level at nom
<-80dBu
MAXIMUM VOLTAGE GAIN (±2dB)
Mic Input to Master Output, 600 ohm load
<-84dB
Aux In to Master Output
<-34dB
Frequency Response - 20Hz-20Khz
+0/-0.5dB
Crosstalk - between any inputs or outputs 20Hz-20KHz
<-60dB
VU METERS - Two 6-segment LED meters
0VU = +4dBu
PEAK INDICATORS
Peak Clip indicator on each input channel and left and right
outputs, illuminates 3dB below clipping
PHANTOM POWER
+48 VDC applied to all Mic Inputs, switchable on front panel.
Maximum total current draw = 80mA.
Maximum single channel current draw = 14mA.
Gradual power-up and down to eliminate"pops".
SHIPPING WEIGHT
13 lbs. Maximum
POWER REQUIREMENTS
100-240 Volts, 50-60 Hz, 30 watts
Unless otherwise stated, specification conditions are: 150 source, Input set at "-40", all
other controls set at nominal.
Safety Instructions – 3
Introduction - 4
MX-206 Mixer – 5
Connectors & Cables – 5
Physical Description - 6
Installation – 7
Typical Applications - 8
Troubleshooting - 9
Dimensions - 9
Specifications - 10
Warranty - 11