Filter
Top Products
P
R
O
F
E
S
S
I
O
N
A
L
B 52
-
3383 Gage Avenue, Huntington Park, CA, 90255
Phone: 323-277-4100 Fax: 323-277-4108
National: 1-800-344-4ETI
Internet: www.B-52PRO.com
E-mail: information@B-52PRO.com
SUGGESTED APPLICATIONS:
Mobile DJ * Karaoke * Nightclub, Restaurant, Bar Install * Corporate Audio / Video *
Home Entertainment System * Live Sound System * Stage Monitoring System * Booth
Monitoring System
MATRIX-600 Specifications
MIXER:
Sensitivity / Impedance (for 1Vrms on PREAMP outputs,
channels’ VOLUME controls and MASTER VOLUME in FCW position)
Ch. 1-4: XLR and 1/4” TRS combo MIC inputs (balanced): 5 mV / 2 k OhmsΩ
Ch. 1-4: 1/4” TRS LINE inputs (balanced): 50 mV / 20 k Ohms
Ch. 5: XLR MIC input (balanced): 5 mV / 2 k OhmsΩ
Ch. 5: 1/4” TRS INSTRUMENT input (mono, unbalanced): 75 mV / 1 M OhmsΩ
Ch. 5: 1/4” TRS STEREO LINE input (unbalanced): 150 mV / 1 M OhmsΩ
Ch. 6: Stereo RCA and 3.5mm mini jack MP3/CD input
(unbalanced): 50 mV / 10 k Ohms
Ch. 7: Stereo RCA HOUSE input
(bypasses MASTER VOLUME): 500 mV / 10 k OhmsΩ
Phantom power on Ch. 1-4: 48Vdc
Channels’ 3-band EQs
Ch. 1-4: Bass: shelf 150 Hz; +/-9 dB
Mid: 1 kHz; +/-6 dB
High: shelf 8 kHz; +/-9 dB
Ch. 5-6: Bass: shelf 100 Hz; +/-9 dB
Mid: 2 kHz; +/-6 dB
High: shelf 15 kHz; +/-9 dB
MASTER 7-band EQ: +/-6dB @ 63 Hz, 160 Hz, 400 Hz,
1 kHz, 2.5 kHz, 6.3 kHz, 16 kHz
SUBWOOFER filter: 100 Hz at -3dB
SUBWOOFER output: 2 Vrms
MONITOR output: 3 Vrms
RECORD output: 0.25 Vrms
AMPLIFIER:
Output power: 2x300Wrms into 4 Ohms
Frequency Response (with filters and EQs disabled): 20 Hz – 20 kHz, +0/-1dB
Total Harmonic Distortion (at -10dB from rated power): <0.05%
Signal/Noise ratio
(A-weighted, reference to rated power): better than 100dB
LOUDSPEAKERS:
Enclosure: 3-Way, rear ported bass reflex, black painted
Woofer: 10” high excursion
Mid range driver: 6.5” transducer
Compression driver: 1” Phenolic on exponential horn
Frequency response: 50 Hz – 20 kHz
X-over frequencies: 500 Hz, 2.5 kHz
GENERAL SYSTEM:
Weight: Amp/mixer 29 lbs (13.1 kg)
Weight: Loudspeaker (each) 45lbs (20.4 kg)
Dimensions: Amp/mixer 10” x 17” x 10.25”
(W x H x D) (254mm x 432mm x 260mm)
Dimensions: Loudspeaker 13.25” x 24” x 12.25”
(W x H x D) (each) (337mm x 610mm x 311mm)
Note: Specifications are subject to change without notice
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment. This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.