Filter
Top Products
ACTIVE/
PASSIVE
SWITCH
In the Passive posi-
tion, the instru-
ments signal is
routed straight
from the input to
the Jensen trans-
former and then
directly to the XLR
output. This is a strictly passive, impedance-match only mode. In
this mode, the Sonic Maximizer function is not available.
In the Active position, the instruments signal is fed to a Buffer Amp
with an input impedance of 1Meg Ohm. In this mode the Sonic
Maximizer function is available. The signal is then routed to the
Jensen transformer balanced XLR output.
LOW
CONTOUR
CONTROL
Regulates the amount
of phase corrected
bass frequencies.
PROCESS
CONTROL
Regulates the
amount of phase
correction.
IN/OUT TOGGLE
SWITCH
Engages the Sonic
Maximizer Process.
PAD SWITCH
The Pad switch is used to select the
desired gain range of the DI-1000.
When switched to –30dB the DI-
1000 will accept the speaker-level
output of your instrument amplifier.
1/4” INPUT
CONNECTOR*
The 1/4” input connector of the
DI-1000 is unbalanced. The 1/4”
input is designed for running
instrument cables directly
into the DI-1000.
1/4” THRU
CONNECTOR*
This 1/4 “ connector
is wired in parallel to
the Input connector
and is used for con-
tinuing the connec-
tion to the instru-
ment amplifier.
FRONT PANEL
5
*WARNING
When connect-
ing the speaker
level output of a
tube amplifier to
the input of the
DI-1000, a speak-
er load (cabinet)
must be connect-
ed to the Thru
Connector or
damage to your
tube amplifier
will occur.