Filter
Top Products
iAXE USB-GUITAR
Installation for Mac 5
System Performance4) = rapid (or even highspeed).
Clicks or dropouts in recording
Start the 1) ASIO-USB Control Panel from within the audio soft-
ware (may be called ASIO Cong or similar).
USB Device2) = BEHRINGER USB AUDIO.
Click on the 3) ASIO tab.
System Performance4) = normal.
Visit www.musicXP.net for some helpful advice about optimizing
Windows XP for music applications.
Installation for Mac3.
Installing the iAXE3.1
To setup the iAXE, proceed as follows:
Power on your computer.1)
Connect the iAXE with the USB cable to your Mac.2)
Installing the Guitar Combos software3.2
The Guitar Combos software consists of three different combos.
Choose any or all of them for installation. With the serial number on
the CD sleeve you can fully activate one combo. The other combos
can be run in demo mode with the following restrictions:
Saving of sounds is disabled =
Quits after 30 minutes =
Total recall is disabled =
To install a combo on your system, proceed as follows:
From the folder "NI Guitar Combos" on your CD, choose the 1)
combo you wish to install and open the respective archive le
(ZIP) by double-clicking on its entry.
Double-click on the installer icon on the desktop, to start the 2)
installation.
Follow the on-screen instructions.3)
If you have the serial number for the installed combo:
Accept to start the 4) NI Service Center, upon request.
If your computer is not connected to the internet, choose +
the ofine registration method to activate the combo via
another computer.
Follow the on-screen instructions.5)
Product activation with NI's Service CenterFig. 3.1:
If you do not have the serial number for the installed +
combo, you can only run the combo in demo mode.
To setup the combo, proceed as follows:
Start the stand-alone application of a combo.1)
In the 2) Audio Setup window, make your choice according to
the screenshot.
Please note, when using the Guitar Combos plug-in inside 3)
a host application (for example, audio recording software
such as energyXT2), all the signal routing is determined in
the host application.
As of OS 10.X the stand-alone version of Guitar Combos +
needs an "Aggregate Device" for accessing inputs and
outputs of the hardware. For more information on how to
set up an Aggregate Device, visit www.behringer.com.
Audio Setup settings on OS 10.4 and aboveFig. 3.2:
With the 4) Output Latency slider, choose a setting below
16 ms.
Installing Audacity3.3
Audacity is a free software for recording and editing sounds.
To install the software, proceed as follows:
Double-click on "audacity.exe" in the "Audacity" folder.1)
Follow the on-screen instructions.2)
Start the application and go to 3) File > Preferences.
In the 4) Audio I/O tab, set the Playback and Recording devices
to USB Audio Codec.
Audio Setup settingsFig. 3.3:
Restart the application.5)