Behringer C-4 Microphone User Manual


  Open as PDF
of 2
 
Page 2 of 2
©2011 Red Chip Company Ltd. Technical specifi cations and appearance subject to change without notice. The information contained herein is correct at the time of printing. All trademarks are the property of their respective owners. BEHRINGER accepts no liability for any loss which
may be suff ered by any person who relies either wholly or in part upon any description, photograph or statement contained herein. 985-10000-00387
For service, support or more information contact the BEHRINGER location nearest you:
Europe Tel.: +49 2154 9206 4149
Fax: +49 2154 9206 4199
USA/Canada Tel.: +1 425 672 0816
Fax: +1 425 673 7647
Singapore Tel.: +65 6845 1800
Fax: +65 6214 0275
Australia Tel.: +61 03 9877 7170
Fax: +61 03 9877 7870
Japan Tel.: +81 3 5281 1180
Fax: +81 3 5281 1181
The cardioid pickup pattern provides
unparalleled sound source separation
and feedback rejection. C-4 mics contain
ultra low-noise transformerless FET input
circuitry that can handle extreme dynamics
(from 20 Hz to 20 kHz) and has a maximum
sound pressure level of 136 dB. So even if the
featured performer at your next recording
session or live show happens to be a
revved-up jet engine, this workhorse mic
will not distort!
C-4 mics also feature a switchable
low-frequency rollo to eliminate infrasonics
(mic handling noise, nasty sound created
by creaky stages), as well as a switchable
-10 dB input attenuation to accommodate
for hot signals, such as a really loud vocalist or
overzealous cellist.
But wait, there’s more…
The C-4 mics not only sound great,
they come packed with custom stand
adapters, windscreens, a stereo bar for
mounting both mics in stereo alignment,
and a transport case. As soon as you break
them out of the box, these mics are ready
to become a mind-blowing addition to
your sound arsenal.
XENYX 802
UCA222
USB Audio Interface
C-4
Choir
Laptop
Live Recording
EUROLIVE B312A
C-4
Acoustic
Grand Piano
Live Performance
Switchable low-
frequency roll-o
Switchable
-10 dB input
attenuation
The
transducer
is where the
C-4 collects
sound
Gold-plated
XLR output
Transducer type condenser, 16 mm (0.63")
Polar pattern cardioid
Connector gold-plated balanced XLR connector
Open circuit sensitivity (@ 1kHZ) -38 dBV (0 dBV = 1 V/Pa)
Frequency response 20 Hz to 20 kHz
Level attenuation -10 dB, switchable
Low-cut  lter 6 dB/oct. @ 120 Hz (switchable)
Max. SPL (≤ 1 % THD @ 1 kHz) 136 dB
Nominal impedance 75 Ω
Load impedance > 1 kΩ
Supply voltage +48 V
Supply current 3 mA
Dimensions Ø shaft: 0.9", length: 3.7"
Ø shaft: 23 mm, length: 94 mm
Weight approx. 0.1 lbs/approx. 0.06 kg
Please note these speci cations are preliminary and conceptual in nature, and as
such are subject to change as product development progresses. This information is
supplied for market research purposes only and is not to be made public in any manner.
This document is solely the property of The MUSIC Group, or one of its subsidiaries, and
must be surrendered upon request of the owner.
SINGLE DIAPHRAGM
CONDENSER
MICROPHONES
C-4
 previous