7 EUROPORT EPA40 User Manual
(9) You can connect an external sound source (CD player,
MP3 player, etc.) to the LINE IN input.
DC IN 18V 3A
(1)
(3) (2) (3)
(11)(8)(5)(4) (9) (7) (6)(10)
Fig. 2.1: Side view of the EPA40
(10) Connect to the power supply via the polarized DC IN connector.
Atting power adapter is supplied. Use the device only with the
included powersupply.
(11) COMPARTMENT FOR BATTERY AND SHOULDER STRAP.
To insert the battery, open the compartment’s cover.
The bottom half of the compartment is used for the battery.
Open the latch to access the battery compartment.
Insert the battery as follows: The terminals must face the device
with the positive terminal (red) on the side of the EPA control
panel (to the left, asseen from the rear panel). Insert the
battery and close the latch. Close the battery compartment.
◊ Insert the rechargeable battery with the terminals
connected to the correct polarity.
◊ Remove the rechargeable battery when the device is not to
be used for a long period. Store the rechargeable battery in
an upright position (with the terminals facing upward).
The device’s SERIAL NUMBER is found on the bottom side of the unit.
3. Specications
Inputs
MIC IN ¼" TRS jack, unbalanced
LINE IN ⁄" jack, unbalanced
Output
Output power 40W
Loudspeaker 5" full-range speaker
Microphone
Type BEHRINGER XM1800S,
dynamic
Pickup pattern Hyper-cardioid
Cable length 3' spiral cable
System Data
Power supply with built-in
rechargeable battery
Rechargeable battery type 12V DC / 2600mAh
Charging time approx. 4h
Battery operating time up to 8h
External recharger type 18V DC / 3A
Mains voltage 100 - 240V~, 50/60Hz, 1.5A
(Switching mode adaptor)
Mains connector Standard IEC receptacle
Physical/Weight
Dimensions (H x W x D) approx. 8.5 x 7.1 x 11.2"
approx. 217 x 180 x 284mm
Weight (without power supply) approx. 7lbs / 3.20kg
BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these
efforts, modifications may be made from time to time to existing products without prior notice.
Specifications and appearance may differ from those listed or illustrated.