Filter
Top Products
16 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual
Wiring Examples5.
For stereo operation the POWER AMP switch (27) must be set to its upper position
(MAIN or MAIN L/MAIN R). Outputs A and B provide the stereo main signal for
passive speakers. The preamp monitor output is connected to two parallel active
speakers, which are used as on-stage monitors. Use the footswitch to enable/
disable the effects processor.
This illustration shows the power mixer with a sub-woofer connected to
OUTPUT B. For a bridged mono operation to OUTPUT B, the AMP MODE selector
switch (27) must be set to its lower position “BRIDGE”. A separate stereo power
amp (BEHRINGER EUROPOWER EP2000) connected to the preamp main outputs
delivers the stereo main signal. Two active monitor speakers for on-stage
operation are connected to the preamp monitor output.
Loudspeaker connection (monitor mix)
Loudspeaker connection (monitor mix)
PMP1000
PMP4000
PMP6000
(part view)
2 x BEHRINGER EUROLIVE Stack
(B1800X & B1220, both passive)
2 x BEHRINGER F1220D
(active)
front panel (part view)
Footswitch
Link Output
Fig. 5.1: Stereo operation
Subwoofer
PMP1000
PMP4000
PMP6000
Rear panel
EUROPOWER EP2000
EUROLIVE
VP1520
EUROLIVE B1800X
Subwoofer
2 x BEHRINGER F1220D
(active)
F. O.H. mix Monitor mix
Fig. 5.2: Bridged mono operation