Behringer x32 Music Mixer User Manual


 
34 X32 DIGITAL MIXER Preliminary User Manual
This mode obviously allows the full potential of the interface to be tapped.
Notethat the computer needs to be able to handle that amount of concurrent I/O
stream without any glitches. Depending on its speed and memory conguration,
someoptimization for audio recording might be required.
It is also possible to run a virtual sound check of all 32 input channels by recording
them directly to a computer during a brief line check. The performers can leave
the stage while you play back the recorded instruments from the hard drive and
tweak the sound accordingly.
32 in / 32 out
STANDARD MODE: When console channel inputs are set to Card,
channelGaincontrol will be a digital trim for the interface card signal only,
without access to any head amp. Please consider this if you intend to pass all
signals through a connected PC for plug-in processing. A compromise can be to
run only 24channels (3 blocks of 8) through the PC via XUF and use the remaining
block of 8 channels to access the head amps.
The Card outputs may use any of the available sources in the console
(local or AES50) for recording independently.