Behringer XL1600 Music Mixer User Manual


  Open as PDF
of 23
 
9 XENYX XL3200/XL2400/XL1600 User Manual
4. Connectors
Let's begin with the rear panel where the majority of inputs and outputs
arelocated.
4.1 Power supply
IEC receptacle
The mains connection is a standard IEC receptacle. Anappropriate power cord is
supplied with the unit.
FUSE HOLDER
Before connecting the unit to the mains, ensure that the voltage setting matches
your local voltage. Blown fuses should only be replaced by fuses of the same type
and rating. Please also read the information given in chapter “Specications.”
POWER
Use the POWER switch to turn on the mixing console. The POWER switch
should always be in the “O” position when you are about to connect your
unitto the mains.
To disconnect the unit from the mains, pull out the main cord plug.
Wheninstalling the product, ensure that the plug is easily accessible.
Ifmountingin a rack (XL1600 only), ensure that the mains can be easily
disconnected by a plug pull or by an all-pole disconnect switch on or near
therack.
◊ Please note: The POWER switch does not fully disconnect the unit from
the mains. To disconnect the unit from the mains, pull out the main
cord plug or appliance coupler. When installing the product, ensure the
plug or appliance coupler is readily operable. Unplug the power cord
when the unit is not used for prolonged periods of time.
SERIAL NUMBER
This is the serial number of the mixing console.
4.2 Mono inputs
MIC
The balanced XLR input connects to microphones, DIboxesand multicores.
(Multicores are cables that have multiple cores and which run from the so-called
stagebox to the mixer.)
◊ Connect the microphone and mute all mixer outputs before turning on
the phantom power to avoid noise when the microphone is turned on.
Please wait for about one minute when switching on the mic until the
voltage is stable. Only then turn on the input amplification.
◊ Caution! Never use unbalanced XLR connectors (pins 1 and
3 interconnected) on the MIC input jacks, if you want to use
phantom power.
+48 V
Phantom power is used for operating a capacitor microphone. A control
LED lights up next to the switch when the phantom power supply is active.
Additionalcontrol LEDs are located in each Trim section of the mixer's
channels. As a rule, dynamic microphones can still be used with phantom
power, providedthey are wired in a balanced conguration. In case of doubt,
contactthemicrophone manufacturer!
LINE
This is a ¼" jack connector which connects to line-level signal sources
(forexample, keyboards, CD players and wireless microphone receivers).
The input is balanced (TRS connector) but can also be used with unbalanced
connectors (TS connector).
 previous next