Filter
Top Products
Technical Support
Should you have any questions regard-
ing the operation or repair of this nail-
er, please call our Nailer Hotline at
1-800-543-6400 for assistance. If you
are calling from Ohio or outside of the
continental United States, please call
collect, 1-513-367-1182.
Record the model number and
serial number below:
Model No___________________________
Serial Number_______________________
Retain these number for future
reference.
Fastener And Replacement
Parts
Use only
genuine Campbell
Hausfeld fasteners (or equivalent) and
replacement parts. Do not use modi-
fied parts or parts which will not give
equivalent performance to the original
equipment. Tool performance, safety
and durability could be reduced. When
ordering replacement parts or fasten-
ers, specify by part number.
Model NB0050
5
Operating Instructions
4. The driver
cover plate can
now be rotat-
ed, exposing
the jammed
fastener.
5. Remove the
jammed fas-
tener, using
pliers or a
screwdriver if
required.
6 Rotate driver
cover back into
the closed posi-
tion.
7. Extend the
wire latch and
place over the
hooks on the
nose casting.
8. Close the over
center latch by
pushing the
latch in until
the latch snaps
into place.
Fasteners
The following Campbell Hausfeld finishing nails are available at local retail stores. If you need help locating
any item, call customer service at 1-800-543-6400. Campbell Hausfeld nails meet or exceed Federal
Specifications FF-N-105B.
Shank Nails Per Nails Per
Model # Length
Gauge
Finish Head Collation
Stick Box
FB003060 1-1/4” 16 Gauge Galvanized Brad Adhesive 50 2500
FB004060 1-1/2” 16 Gauge Galvanized Brad Adhesive 50 2500
FB004560 1-3/4” 16 Gauge Galvanized Brad Adhesive 50 2500
FB005060 2” 16 Gauge Galvanized Brad Adhesive 50 2500
Interchange Information
Nails used in the Campbell Hausfeld NB0050 Finishing Nailer will also work in Hitachi NT65A, Paslode 3250-F16, IM250F,
Duo Fast LFN-764, Sears 18314, Porter Cable FN200 and FN250.
COLORMATCH™ System
The Campbell Hausfeld Finishing Nailer
has a unique COLORMATCH™ stripe.
Look for the COLORMATCH™ stripe to
choose the right Campbell Hausfeld
fasteners for your NB0050 2” finish
nailer.
Nailer Repair
Nailer repairs must be performed by
qualified and experienced service peo-
ple ONLY.
Assembly Procedure For
Seals
When repairing a nailer, the internal
parts must be cleaned and lubricated.
Parker O-lube or equivalent must be
used on all o-rings. Each o-ring must be
coated with O-lube before assembling.
A small amount of oil must be used on
all moving surfaces and pivots. After
reassembling, a few drops of 30W non-
detergent oil or equivalent, must be
added through the air line before test-
ing.