Filter
Top Products
E-30
702A-E-032A
Real-time Recording to Track 2
After you record Track 1, you can use real-time recording to add a
melody in Track 2.
To record to Track 2 while playing back Track 1
1. Use the MEMORY button to enter record standby, and
then use [+] and [–] to select 0 or 1 as the song number.
• The song number you select should be the one where you
previously input Track 1.
• The track is not yet selected at this point.
2. Press the RIGHT/TRACK 2 button to select Track 2.
3. Make any of the following settings if you want.
• Tone number (page E-14)
• If you are not confident about playing at a fast tempo, try
using a slower tempo setting (page E-16).
4. Press the START/STOP button to start real-time re-
cording to Track 2 along with playback from Track 1.
5. Listening to the playback from Track 1, play what you
want to record to Track 2 on the keyboard.
6. Press the START/STOP button to end recording when
you are finished playing.
• If you make a mistake while recording, stop the record oper-
ation and begin over again from step 1.
❚
NOTE
❚
Track 2 is a melody-only track, so chords cannot be recorded there. Be-
cause of this, the entire keyboard is a melody keyboard, regardless of the
MODE switch setting.
Flash
ETUDE
CONCERT
PIECE
LAYER
SPLIT
GM
TOUCH
RESPONSE
MEMORY
Flash
To record to Track 2 without playing back
Track 1
1. Use the MEMORY button to enter record standby.
2. Press the LEFT/TRACK 1 button to turn off playback
of Track 1.
3. Continue from step 1 under “To record to Track 2 while
placing back Track 1.”
• Note that the above procedure does not turn off rhythm and
Auto Accompaniment.
Track 2 Contents After Real-time Recording
The following data is recorded to Track 2 during real-time recording.
• Tone number
• Pedal operations