Filter
Top Products
E-40
Auto Accompaniment
Finishing with an Ending Pattern
You can end your performances with an ending pattern that
brings the rhythm pattern you are using to a natural-sounding
conclusion.
The following procedure describes how to insert an ending
pattern. Note that the actual ending pattern played depends
on the rhythm pattern you are using.
To finish with an ending pattern
1
While the rhythm is playing, press the SYNCHRO/
ENDING button.
• This causes the ending pattern to play, which brings
rhythm accompaniment to an end.
NOTE
• The timing when the ending pattern starts depends on
when you press the SYNCHRO/ENDING button. If you
press the button before the second beat of the current
measure, the ending pattern starts playing immediately.
Pressing the button at any point in the measure after
the second beat results in the ending pattern playing
from the beginning of the following measure.
Using One-touch Preset
One-touch preset automatically makes the settings listed
below in accordance with the rhythm pattern you are using.
• Keyboard tone
• Layer, Split, or Layer Split on/off
• Layered tone (when layer is turned on), split tone (when
split is turned on), or layered split tone (when layer and
split are turned on)
• Tempo
• Accompaniment volume
To use one-touch preset
1
Select the rhythm you want to use.
2
Use the MODE switch to select the accompaniment
mode you want to use.
3
Press the ONE TOUCH PRESET button.
• This automatically configures the one-touch preset
settings in accordance with the rhythm you selected,
and enters synchro start standby.
4
Play a chord. This will cause the rhythm pattern to
start to play automatically.
• Accompaniment is played using the one touch preset
settings.
704A-E-042A
ONE TOUCH PRESET
SYNCHRO/ENDING
MODE
CTK591_e_32-40.p65 03.10.7, 4:27 PM40