Filter
Top Products
Using the Pattern Sequencer
E-114
The event editor screen shows the individual events recorded
to an instrument part as shown in the sample screen below.
• The event editor screen shows three events at one time.
The event in the middle line is the selected event. You can
change the value where the solid-line cursor is located. A
broken line under a setting value indicates that the cursor
can be moved to that value.
• The values in the format “001:01:00” at the beginning of the
event indicate the recording location (timing) of the event as
measure:beat:tick. A “tick” is a time unit that is shorter than
one beat. Pattern sequencer data uses 96 ticks per beat
(for 2/4 to 8/4) or 48 ticks per beat (for 2/8 to 16/8).
Pattern sequencer records three types of events: notes
(keyboard play), pitch bender operations, and modulation
operations. These events are represented on the screen as
described below.
● Notes
The note name is indicated to the right of the event location
information, followed by the gate time (note length), and
velocity (note speed) parameters.
shows an abbreviation of
the parameter name where the cursor is currently located.
● Pitch bender, modulation
“Bend” (pitch bender even) or “Mod” (modulation event) is
indicated to the right of the event location information,
followed by parameter value. “VALU” is displayed at
when
the cursor is located at a parameter value.
■Settings
* When “C-” is displayed, it indicates C-1 (one octave below
C0).
Event Editor Screen Contents
Event being edited (selected event)
Cursor
Events before (previous event) and after
(following event) the current event
1
Gate time (GATE)
Velocity (VEL)Note name (NOTE)
Event Parameters Setting Range
Note
Note name C- to C0 to G9
*
Gate time 00:00 to 99:95
Velocity 000 to 127
Pitch Bender Pitch Bender –8192 to 0000 to +8191
Modulation Modulation 000 to 127
1
Event name (Bend or Mod)
Parameter value (VALU)
CTK7000_e.book 114 ページ ２０１０年７月２１日 水曜日 午後５時１５分