Filter
Top Products
E-19
Using Registration Memory
To store a setup in registration
memory
1
On the digital piano, configure the tone,
rhythm, and other settings you want to save
as your setup.
• See “Registration Memory Setup Data” (page
E-18) for more information.
2
Use the BANK button to select the
registration memory bank where you want
to save the setup.
• This causes the number of the selected bank to
appear on the display for about two seconds. If
you do not perform the following step within
that time, the bank selection screen will
disappear.
Example: Bank 1 selected
WARNING
• The following step will replace the setup currently in the
area you select with the new setup. Make sure you do not
need the current setup before performing the next step.
3
While holding down the STORE button,
press the REGISTRATION button (1 to 4)
that corresponds to the area where you
want to store the setup.
• You can also change the bank selection at this
time by pressing the BANK button while
holding down the STORE button.
Example: After button 2 is pressed
4
Release the REGISTRATION and STORE
buttons.
To recall a setup from registration
memory
1
Use the BANK button to select the
registration memory bank that contains the
setup you want to recall.
• This causes the number of the selected bank to
appear on the display for about two seconds. If
you do not perform the following step within
that time, the bank selection screen will
disappear.
2
Press the REGISTRATION button (1 to 4)
for the area that contains setup you want
to recall.
NOTE
• If you press a REGISTRATION button without
selecting a bank first, the digital piano will recall
the setup from the applicable area in the bank you
previously last selected.
Registration memory contents are retained even
when you turn off digital piano power (page
E-25).
407A-E-021A