Casio PX575R Musical Instrument User Manual


 
E-53
Song Memory Function
Track 1 Contents After Real-time
Recording
In addition to keyboard notes and accompaniment chords,
the following data is also recorded to Track 1 during real-
time recording. This data is applied whenever Track 1 is
played back.
Tone number
Rhythm number
INTRO/ENDING 1 button, INTRO/ENDING 2 button,
VARIATION/FILL-IN 1 button, VARIATION/FILL-IN 2
button, SYNCRHO/FILL-IN NEXT button operations
Pedal operations
The following data is recorded in the header whenever you
start a recording of a track.
Mixer settings of other tracks
Effect type
Accompaniment volume
Reverb Level
Chorus Level
DSP Hold On/Off
Mixer Hold On/Off
Pitch bend wheel operation
Pitch bend range
Mixer Mode Settings
Channel 1 Mixer parameters (page E-39) are automatically
recorded to Track 1. You can use the Mixer to change each of
the parameters.
Memory Capacity
The digital piano has memory for approximately 10,000 notes.
The measure number and note number flash on the display
whenever remaining memory is less than 100 notes.
Recording automatically stops (and auto-accompaniment
and rhythm stops playing if they are being used) whenever
memory becomes full.
Initially, nothing is stored in song memory.
Memory Data Storage
Whenever you make a new recording, anything previously
stored in memory is replaced.
Turning off the digital piano while a record operation is in
progress causes the contents of the track your are currently
recording to be lost.
You can save memory data to SD memory cards, if you
want. See Saving Data on page E-80 for more information.
Remember that you can dump memory contents to a
computer using the procedure described under Internet
Data Expansion System on page E-79.
Track 1 Real-time Recording
Variations
The following describes a number of different variations you
can use when recording to Track 1 using real-time recording.
All of these variations are based upon the procedure described
under To record with real-time recording on page E-52.
To start recording with synchro start
In place of step 4, press the SYNCHRO/FILL-IN NEXT
button. Auto-accompaniment and recording will both start
when you play a chord on the accompaniment keyboard.
To record using an intro, ending, or fill-in
During recording, the INTRO/ENDING 1/2, SYNCHRO/
FILL-IN NEXT, and VARIATION/FILL-IN 1/2 buttons
(pages E-34 to 35) can all be used as they normally are.
To synchro start Auto Accompaniment with an intro
pattern
In place of step 4, press the SYNCHRO/FILL-IN NEXT button
and then INTRO/ENDING 1 or INTRO/ENDING 2 button.
Auto-accompaniment will start with the intro pattern when
you play a chord on the accompaniment keyboard.
To start Auto Accompaniment part way into a recording
In place of step 4, press the SYNCHRO/FILL-IN NEXT button
and then play something on the melody keyboard to start
recording without Auto Accompaniment. When you reach
the point where you want accompaniment to start, play a
chord on the accompaniment keyboard to start Auto
Accompaniment.