Filter
Top Products
Often, th
and
tha
initiali
settings
switch
tha ollow may also require a slave
setting. Please consult the
“Operating Instructions” section in
this manual for complete instructions
for this type of setup and
configuration.
e setup for Master-Slave
Standalone operation requires
t the first fixture in the chain be
zed for this purpose via either
in the control panel or DIP-
es. Secondarily, the fixtures
t f
Hanging Clamp
Note!
Clamp is sold separatel
y
.
Master/Slave
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector
of the first fixture.
e coming from the first fixture which will have a (female) 3 pin
ctor of the next fixture consisting of a (male) 3 pin connector. Then,
ounting
RIENTATION
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the
fixture by loosening both knobs and tilting the fixture. After finding the
desired position, retighten both knobs.
•
•
• will be exposed to rain, high
or restricted ventilation.
Fixture Linking
2. Connect the end of the cabl
connector to the input conne
proceed to connect from the output as stated above to the input of the following fixture and so on.
M
O
fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
Safety cables must always be used.
Never mount in places where the fixture
humidity, extreme temperature changes
MiNWash 9 2007-09-14/09:44