Filter
Top Products
3. Setup
AC Power
Warning! Verify that the power requirement label on your unit matches the line voltage
applied. All fixtures must be connected to circuits with a suitable Earth Ground.
• To determine the power requirements for a particular fixture, see the label affixed to the back plate
of the fixture or refer to the fixture’s specifications chart.
• A fixture’s listed current rating is its average curren
t draw under normal conditions.
• All fixtures must be powered directly off a s
witched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%
to 100% switch.
• Before applying power to a fixture, check that the source voltage matches the fixture’s
requirement.
• All fixtures must be connected to circuits w
ith a suitable Earth Ground.
Power Cable Configuration
CABLE Pin International Screw Color
BROWN Live L Yellow or Brass
BLUE Neutral N Silver
YELLOW/GREEN Earth EG (Ground) Green
Mounting
Orientation
This power relay-pack can be mounted on a truss using a clamp in any position or against a flat
surface using the screw holes
Rigging
Hanging Clamp
Surface
mounting
The relay pack includes (3) clamp mounting holes for convenience
of placement. You only need to use one to adhere to a truss or light
stand. You must supply your own clamp and make sure the clamp is
capable of supporting the weight of the relay pack. You can order C-
clamps from any CHAUVET dealer or distributor.
1. Block access below the work area and use
suitable and stable platform when installing or
servicing the relay pack.
2. Affix clamp to relay-pack u
sing any of the (3)
clamp holes provided.
3. Verify the structure can hold 10 times the weight
of al
l to-be installed fixtures.
4. Always use a safety cable or chain as a
secondary
source of attachment. The safety
cable must hold 10 times the weight of the
accessory. If safety cable attachment point is
provided that is permanently affixed to the
surface or body of the fixture, use that instead of
looping through a hanging yoke/arm.
FS-4200 User Manual 7 2007-02-13
/14:05