Filter
Top Products
An identifier for the TCP or UDP port that the Server or application is listening on, along
with the IP address for incoming connection requests when acting as a server.
•
Remote Protocol/Port:
The identifier for the TCP or UDP port that the remote service or application is listening on,
along with the IP address for incoming connection requests when acting as the server.
•
Remote Device:
The remote application or device making a connection to the server or service specified by
the protocol; or listening on the remote protocol/port.
Note: The source port the local application or service uses to connect to a remote device’s
destination port is not specified because it is always dynamically assigned by the Operating
System. In most cases, this port is assigned randomly above TCP/UDP 1024.
Cisco Unified Customer Voice Portal Port Utilization
For Cisco Unified Customer Voice Portal Release 4.0.
Table 1: Cisco Unified Customer Voice Portal Port Utilization
NotesRemote DeviceRemote
Protocol/Port
Server Protocol/PortServer or
Application Protocol
Cisco Unified Customer Voice Portal
CVP Message Bus
communications
CVP SubsystemTCP 23000 - 28000 (First
available)
CVP Messaging Layer
Listen port for incoming SIP
requests. Port is configurable.
SIP endpointsUDP 5060
TCP 5060
CVP SIP Subsystem,
SIP Proxy Server,
Gateway, Cisco Call
Manager: SIP (Session
Initiation Protocol)
VXML over HTTP.
Calls/sessions answered on port
IOS VXML
gateways
TCP 7000CVP VXMLServer:
HTTP
7000 by HTTP server which
relays request to WAS on local
system port 9080.
Port restricted to local access
only
Local machineTCP 7005CVP VXML Server
with Tomcat
AJP/1.3 ConnectorTCP 7009CVP VXML Server
with Tomcat
VXML over HTTPVoice BrowsersTCP 8000CVP IVR Subsystem:
HTTP
Port restricted to local access
only
Local machineTCP 8005CVP IVR Subsystem:
HTTP
Port Utilization Guide for Cisco Unified Customer Voice Portal Release 4.0(1)
4
Chapter 1: - Cisco Unified CVP Port Utilization
Cisco Unified Customer Voice Portal Port Utilization