Filter
Top Products
6
28 29 30 31 32 33 34
The Rear Panel:
28: FOOTSWITCH: Use this jack to connect the footswitch cable (5-conductor midi cable) to the four-button
footswitch (supplied). This allows you to remotely switch between the channels, set tap tempos, save new presets,
and access a second set of DSP presets. (See page 9 for additional information.)
29: MONO EFFECTS LOOP SEND: When using a mono external effects processor, connect this jack to the input
jack of the effect by means of a shielded signal cable.
30: MONO EFFECTS LOOP RETURN: When using a mono external effects processor, connect this jack to the
output jack of the effect by means of a shielded signal cable.
31: STEREO EFFECTS LOOP SEND: When using a stereo external effects processor, connect this jack to the
input jack of the effect by means of a shielded three conductor signal cable terminated with a stereo (R/T/S) 1/4”
connector.
32: STEREO EFFECTS LOOP RETURN: When using a stereo external effects processor, connect this jack to the
output jack of the effect by means of a shielded three conductor signal cable terminated with a stereo (R/T/S) 1/4”
connector.
33: SPEAKER OUTPUTS: Use these jacks to connect the amplifier to your speaker(s) by means of speaker cables
with mono 1/4” plugs. The VTX200SH has two separate internal power amplifiers: one for the left channel, one for the
right. The two Left Speaker Output jacks are wired in parallel to each other, as are the two Right Speaker Output jacks.
Make certain the total impedance of your speakers does not go below four ohms per channel. Use the chart below to
help determine parallel loads. If in doubt, ask your dealer.
When using the stereo Chorus effect the right channel is dry and the left channel is detuned (wet). Each channel
will provide 70 watts RMS into an eight ohm load and 100 watts RMS into a four ohm load.
34: AC LINE CORD: This grounded power cord is to be plugged into a grounded power outlet, wired to current
electrical codes and compatible with the voltage, power, and frequency requirements stated on the rear panel. Do
not attempt to defeat the safety ground connection.
VTX200SH
Three-Channel Guitar Amp Head with Stereo DSP
SPEAKER NUMBER OF TOTAL
IMPEDANCE SPEAKERS (PAR) IMPEDANCE
8 ohms 2 4 ohms
16 ohms 4 4 ohms
16 ohms 2 8 ohms
WARNING: The speaker output of this unit can exceed 10 Watts and could be a
shock injury. Connection to speakers should be performed by a skilled person in
compliance with local building codes. Class 2 wiring is required for speaker cables.
Use of external speakers outside the ratings stated at the speaker jack may result
in a shock injury or damage to the unit.