Filter
Top Products
Expression Pedal Calibration
The Expression Pedal on the RP80 needs to be recalibrated for use after a factory reset has
been performed. This calibration procedure is automatically entered after a factory reset
procedure. In the event the Pedal’s calibration fails, or if the Pedal does not function
properly, it can be re-calibrated using the Pedal Calibration procedure. This will not erase
the User Presets. The procedure for Calibrating the Expression Pedal is as follows:
1. Disconnect the PS200R power supply from the power jack on the RP80.
2. Press and hold the Down Footswitch while re-connecting the power.
3. Continue to hold the Down Footswitch until the Display reads Tc.
4. Rock the Expression Pedal back to the toe up position (Display will read UP).
5. Press the Up Footswitch and the Display now shows D
n.
6. Rock the Expression Pedal forward to the toe down position.
7. Press the Down Footswitch. The RP80 will return to the last selected Preset and the
Expression Pedal is now calibrated.
Note: If the Display shows ER, an error has occurred and steps 4 through 7
should be repeated.
25