Filter
Top Products
The ELAR WR IR translater has many differnet functions and gives
you complete control of your Elation® Architectural fixtures.
To control the your desired fixture you must aim the controller at the
front of the fixture and be no more the 30 feet away.
BLACKOUT - Pressing this button will blackout the fixture.
AUTO RUN - This button will run an automatic program. You can
control the speed of the Auto Run by pressing the SPEED button first
and then pressing the “+” and “-” buttons. You can then press the
FLASH button to turn on/off flash (strobe). See FLASH below.
PROGRAM SELECTION - This button will let you access one of the
seven static color selections, color changing mode, or color dream-
ing mode. You can then press the FLASH button to turn on/off flash
(strobe). See FLASH below. Press the SPEED button to adjust the
color changing and dreaming speed. See SPEED below.
FLASH - This button will activate the strobe effect. You can control
the flash rate by pressing the “+” and “-” buttons. Press this button
again to exit strobe mode.
SPEED - Press this button and use the “+” & “-” buttons to adjust the
speed of the Auto run.
DMX MODE - This button will let you select which DMX mode you
want to use. Some fixtures will come with different DMX channel
modes. This button will switch between the different modes. Please
see pages 9-12 for DMX modes, values, and traits.
SOUND ACTIVE - The ELAR EX TRIFLOOD does not have sound ac-
tive mode.
SLAVE - This designates the fixture as a slave fixture in a master/
slave configuration.
SET ADDRESS - Press this button to set the DMX address. Press
this button first, then press the numbers to set the address.
Example: DMX Address 1 Press “S001”
DMX Address 245 Press “S245”
R G B - Press either one of these buttons, and then press the
ELAR EX TRIPAR Operating Instructions
Elation Architectural - www.elationlighting.com - ELAR EX TRIPAR Instruction Manual Page 8
Elation Architectural - www.elationlighting.com - ELAR EX TRIPAR Instruction Manual Page 7
“+” and “-” to adjust the brighness.
“+” and “-” - Use these buttons to adjust the flash rate, speed of the
Auto Run, and program selection
DMX Control:
Operating through an Elation® DMX controller gives the user the
freedom to create their own programs tailored to their own individual
needs. Note: Your fixture has 4 different DMX channel modes. To set
your desired DMX Mode please see below.
1. Before connecting to an Elation® DMX controller, your fixture has
different DMX channel modes, please select your desired mode by
using the DMX Mode button. Set the mode before you address the
fixture. After you have selected your mode, set the DMX address
for the fixture by pressing the “S” button and then use the number
buttons to press in your desired address. See SET ADDRESS for
examples.
2. Now you may connect the fixture via the XLR connections to any
standard Elation® DMX controller. Please see pages 9-12 to for a
detailed descriptions of the DMX modes, values, and traits.
Note: Do not connect to DMX unless you use the defaut
start address of 1.
• If Red LED’s glow you are in DMX Mode 1: 3 DMX Channels
• If Green LED’s glow you are in DMX Mode 2: 4 DMX Channels
• If Blue LED’s glow you are in DMX Mode 3: 5 DMX Channels
• If Red & Green LED’s glow you are in DMX Mode 4: 6 DMX
Channels
ELAR EX TRIPAR Operating Instructions