Electro-Voice RE510 Microphone User Manual


 
Frequency Response:
12000 Portland Avenue South, Burnsville, MN 55337
Phone:952/884-4051, Fax:952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 6/2006
Part Number 38110-130 Rev D
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 736-4212
For warranty repair or service information, contact the Service Repair department at:
800/553-5992 or 402/467-5321
For technical assistance, contact Technical Support at: 800/392-3497 or 952/736-4656
Specifications subject to change without notice.
Polar Response:
Microphone Use and Placement
Please note that micing techniques are a matter of personal
preference. These are merely guidelines to assist in the placement
of the microphone to gain optimal performance.
Usage Optimal Placement
Vocals Zero to six inches from the windscreen, and on
axis with the microphone.
Spoken Word Five to ten inches from the windscreen, and on
axis with the microphone.
Dimension Drawing:
RE510 Part Number: 301259-000
Standard Placement & Use Guidelines
1. Always point the microphone at the desired source of sound, and
away from any unwanted sources.
2.The microphone should be located close to the sound source to
minimize interference from other potential sound sources.
3. Use the 3-to-1 rule when using multiple microphones. Place each
microphone three times farther from other microphones as from the
desired sound source.
4. Minimize over-handling of the microphone to reduce unwanted
mechanical noise.
5.Working close to the microphone will increase the bass tone and
also provide increased gain-before-feedback.
Low Frequency Selector Switch
Location: