Filter
Top Products
8. SLIDER ASSIGN
Moving the SLIDER transmits MIDI CONTROL CHANGE messages to any connected equipment. The Slider
defaults to sending Channel Volume messages on the selected channel, but you can re-assign the slider to any
other controller.
Number
1 – 127
128
129
130
131
132
Functions
Standard MIDI controllers
Pitch Bend Sensitivity
Fine Tune
Coarse Tune
Channel Pressure
Velocity
With Evolution 249/361. Press the SLIDER ASSIGN switches (PROGRAM & BANK LSB) together and the LED
starts to flash showing the number of the present MIDI controller.
Use numeric keys 0-9 to select a new MIDI controller. You can also use the +/- switches to increase or
decrease the value of the number.
With Evolution 225C/249C/361C. Press the CONTROL SELECT switches (MEMORY & PROGRAM) and the
LED starts to flash showing the number of the present MIDI controller.
Move the slider. Alternatively, press numeric keys 0-9 to select a new MIDI controller. You can also use the +/-
switches to increase or decrease the value of the number. The LED display should flash C13.
Note: * If you do nothing for 3 seconds, the LED will return to show the current PROGRAM CHANGE number.
* If the number you press is not in the range of defined numbers, the previous number will be retained.
* When you assign 120 or 121 as the MIDI controller for the WHEEL, you should move the MODULATION
Wheel to the mid-value then return it to the minimum value to send a relative MIDI message.
See Appendix B for a full list of controller numbers.
9. PITCH BEND WHEEL
Moving the PITCH BEND WHEEL transmits MIDI PITCH BEND messages to any connected equipment. This
allows you to bend the pitch of a sound up (or down one tone) to add expression to your performance.
To bend the sound up: Move the WHEEL away from you.
To bend the sound down: Move the WHEEL towards you.
10. WHEEL ASSIGN
Use the WHEEL to transmit MIDI CONTROL CHANGE messages. You can select and assign 119 types of MIDI
functions (1-31, 33-95, 102-121, 128-132)
Number
1 –127
128
129
130
131
132
Functions
Standard MIDI controllers
Pitch Bend Sensitivity
Fine Tune
Coarse Tune
Channel Pressure
Velocity
With Evolution 249/361. Press the WHEEL ASSIGN switches (MEMORY & PROGRAM) together and the LED
starts to flash showing the number of the present MIDI controller.
Use numeric keys 0-9 to select a new MIDI controller. You can also use the +/- switches to increase or decrease the
value of the number.
With Evolution 225C/249C/361C. Press the CONTROL SELECT switches (MEMORY & PROGRAM) and the LED
starts to flash showing the number of the present MIDI controller.
Either move the wheel, or press numeric keys 0-9 to select a new MIDI controller. You can also use the +/- switches
to increase or decrease the value of the number. The LED display should flash C14.
Note: * If you do nothing for 3 seconds, the LED will return to show the current PROGRAM CHANGE number.
* If the number you press is not in the range of defined numbers, the previous number will be retained.
* When you assign 120 or 121 as the MIDI controller for the WHEEL, you should move the MODULATION
Wheel to the mid-value then return it to the minimum value to send a relative MIDI message.
* See Appendix B for a full list of controller numbers.