Filter
Top Products
G. PREAMP OUT jack -This jack provides an unbalanced
mono output signal from the preamp. This output can be
used with the POWER AMP IN jack (item H) as a patch
point for mono effects devices. It can also be used to
provide a signal to a recording or sound reinforcement
mixer. In addition, this output can be used to drive
another BXR 60 used as a slave amp. This is done by
connecting a standard guitar cord from the PREAMP
OUT jack of the master amplifier to the POWER
AMP IN jack (item H) of the slave.
H. POWER AMP IN jack - This unbalanced input goes
directly into the power amp. It automatically disconnects
the preamp when used. This jack is useful when using the
effects loop feature, or when using the BXR 60 as a slave
amp.
I. HEADPHONES output jack -This jack allows the use of
stereo headphones for private listening. When this jack is
used, the internal speaker is disconnected. WARNING:
BE CAREFUL WHEN USING HEADPHONES, AS
EXCESSIVE VOLUME WILL RUIN YOUR HEARING!
J. LINE OUT jack - This quasi-balanced output is derived
from the speaker, and is at line level, similar to that of the
PREAMP OUT jack (item G). Since the LINE OUT jack is
post-power amp, it provides a signal that is affected by
the DELTACOMP™ adaptive compressor. The jack is
wired TIP (+), RING (-), and SLEEVE ground. If the LINE
OUT jack is used to connect to a balanced input, it will
greatly reduce hum caused by a ground loop (a
difference in ground potential) between the BXR 60 and
another piece of equipment.
K. POWER INDICATOR - When this LED is illuminated, the
BXR 60 is receiving power.
L. POWER SWITCH - turns the BXR 60 ON or OFF.