First Act None Musical Instrument User Manual


  Open as PDF
of 2
 
First Act
745 Boylston Street
Boston, MA 02116 USA
rstact.com
Customer Assistance
Phone: 888.551.1115
Email: info@firstact.com
Specifications depicted may vary
slightly from product.
First Act, First Act Discovery and
the First Act Discovery logo are
trademarks of First Act Inc.
© 2008 First Act Inc.
All rights reserved.
FG404.M.02
2. Poke a new string through the hole
in the bridge, leaving 3 inches at the
end to tie the string to the bridge.
3. Run the end under the string to make a
loop.
6. Pull the longer end of the string to
tighten further.
5. Thread the end through the loop 2-3 times,
then pull the end to tighten.
8. Turn the tuning peg to wind the
string around the post. Wind the
string above and below itself on the
post.
4. Pull the end back over the top of the
string.
1. Loosen the tuning peg of the
string and remove the string
from the uke.
9. Turn the peg until the string makes a sound when you pluck it.
10. Repeat these steps for all strings. Tune the strings, and trim any excess at the ends.
Safety first! Always ask an adult to help you change strings.
Strings should be replaced when they become dirty or dull-sounding. Change one
string at a time, keeping the other strings in place. This is better for the uke’s neck.
Follow these steps to change strings:
CHANGING STRINGS
7. Pass the other end of the string through
the hole in the tuning post, so that 2
inches of string stick out. Make a loop and
run the end of the string through the hole
again.
 previous