Fishman ABGP Musical Instrument Amplifier User Manual


 
9. WIRING THE OUTPUT JACK
Solder the red wire to the tip (short terminal).
Solder the black wire to the ring (longer terminal).
Solder the shielding to the ground tab.
After soldering, bend the strain relief tabs around the grey jacket.
10 - FASTEN THE JACK IN THE ENDPIN HOLE
Follow this sequence when installing the endpin jack:
1 - Shielding Cap (optional)
2 - First Large Hex Nut
3 - Large Dress Washer
4 - Star Washer
5 - Guitar Endblock
6 - Small Dress Washer
7 - Small Dress Nut
8 - Strap Button
The jack should protrude at least 5/16" and no more than 11/32" outside of
the guitar body for proper fit.
After fitting the small dress washer and nut over the end of the jack, insert
the 3/32" allen wrench through the small hole on the end of the jack.
Tighten the nut with the 1/2" open end wrench while holding the jack in
place with the allen wrench.Thread and hand tighten the the strap button.
NOTE: With the strap button in place, the end of the
jack should protrude slightly to allow proper plug fit.
AGP-2 / ABGP
6