Filter
Top Products
S R M - 8 0 A / E – S I G N A L R O U T E R / M O N I T O R
DAT can receive signals from de vice “Source”,
“B”, “C”, or “D” INPUTS de pend ing on where
you position this knob.
OUTPUT SELECT B: This four-position knob
works like the output select “A” knob de scribed
above. For example, if the “B” RCA OUTPUTS
on the back panel are used for a cassette
recorder, the recorder can receive signals from
stereo device Source, “A”, “C”, or “D” INPUTS.
OUTPUT SELECT C: The SRM-80A’s “C”
OUTPUTS can receive signals from device
“Source”, “A”, “B”, or “D” INPUTS depending
on where you position this knob. For example,
if the “C” RCA OUTPUTS on the back panel
are used for a MiniDisc recorder, the re-
corder can receive signals from stereo device
“Source”, “A”, “B”, or “D” INPUTS.
OUTPUT SELECT D: The SRM-80A’s “D”
OUTPUTS can receive signals from device
“Source” “A”, “B”, or “C” INPUTS. For ex-
am ple, if the “D” RCA OUTPUTS on the back
panel are used for a CD player/recorder, the
re cord er can receive signals from stereo de-
vice “Source”, “A”, “B”, or “C” INPUTS.
MONITOR SELECT: This fi ve-position knob
allows you to select which device you will hear
through your speakers and headphones, the
main console or soundcard mix (Source), or
the output of any devices “A” through “D”.
LISTENING LEVEL: Controls the loudness
level you hear through your speakers. It does
not affect the signal going to any of the stereo
devices connected to the SRM-80A.
MONO: Changes the sound you hear through
your speakers (not in the Headphones) from
stereo to monaural.
DIM: Attenuates the loudness of your speak ers
by about 15 dB, without affecting the level of
the signals going to any of the stereo de vic es or
headphones connected to the SRM-80A. This
is a very useful feature if you are in ter rupt ed
while monitoring, mixing, or dub bing.
MONITOR LEVEL: This high-resolution, 40 x 2
LED bar graph meter allows precise pre-fade
level calibration for all stereo devices con-
nect ed to the SRM-80A.
METER MODE: Located to the right of Mon-
i tor Level Meter, this switch can be set for the
meter to display AVG (VU) or Peak Mode.
SPEAKERS A, B, and C: Selects between
amplifi er / speaker outputs A, B, or C.
TRIM LEVELS: Adjusting these “Set Once”
controls allows you to set all three pairs of am-
plifi ers/speakers to the same listening level.
HEADPHONES: Plug your headphones in
here. The high-power headphone amp pro-
vides excellent audio quality and can drive
low-impedance phones with ease. It may be
wise to disconnect your headphones to avoid
damage when not in use.
HEADPHONE LEVEL: Adjusts the listening
level of the headphones.
REAR PANEL CONTROLS AND
CONNECTIONS
GROUND LIFT: Allows separation of chassis
ground from audio ground and can be used
to reduce hum or buzz. Remember, never
re move the third prong on the SRM-80A’s AC
6