Filter
Top Products
ies into the battery cavity (9) according to the polarity indication
marked on the battery housing. Close the battery cavity.
2. Set the channel selector pins (7) on both the transmitter and
receiver to the desired frequency as indicated on the included
Frequency Chart.
3. Push the power switch (11) to the ON position. The BATT indi-
cator should ash once briey as you turn on the mic indicating
that the mic has sufcient power. If the BATT stays on, it indicates
that the battery has insufcient power and should be changed. If
the BATT does not light at all and the mic does not work, it indi-
cates the battery is dead and you should change the battery. If
the microphone is not going to be used for any length of time,
push the power switch (11) to OFF and remove the battery. Do
not switch the mic on and off rapidly, because you wont get a true
indication from the BATT indicator.
4. Push the audio mute switch (11) to the ON position.
5. The lavalier/ Headset combo wire is the transmit antenna. Do
not roll up, coil or shorten during use. This wire must be kept as
straight as possible.
RECEIVER (UHF-116 AND UHF-216)
Frequency range...................................... USA: 682 – 698MHz
Europe: 854 – 865MHz
Receiving System.......................................... PLL synthesized
Frequency Stability.................................................. +/- 0.05%
Signal-to-Noise Ratio..........................................Over 94dB @
48kHz dev and 60dBuV input
Modulation Mode............................................................... FM
IF Frequency...............................................................10.7MHz
AF Response........................................ 50Hz to 15KHz (±3dB)
T.H.D....................................................Less than 1% (at 1Khz)
Power Supply........................................................12V-18VDC
Audio Output............................................. unbalanced output
Dimensions............................................... 170 x 30 x 103 mm
TRANSMITTER (ALL MODELS):
Frequency range..................................... USA: 682 – 698MHz
Europe: 854 – 865MHz
RF Power Output................................................. 10mW (max)
Oscillation Mode............................................ PLL synthesized
Spurious Emission......................................... More than 50dB
below carrier frequency
Frequency Stability..................... ±0.005% with quartz control
Current Consumption.................................................. <80mA
Battery Type............................................... Two (2) AA Alkaline
Battery Life............................................................... 6-8 hours
TRANSMITTER (HAND HELD):
Microphone Element.................... Unidirectional Dynamic Mic
Polar Pattern...............................................................Cardioid
Current Consumption.................................................. <80mA
Dimensions......................................................... 260 x 51 mm
TRANSMITTER (HEADSET / LAVALIER)
Microphone Element........................................Condenser Mic
Polar Pattern.............................................................. Cardioid
Current Consumption.................................................. <80mA
Dimensions................................................... 66 x 97 x 25 mm
Specications
15
Specications
Especicaciones • Caractéristiques techniques • Technische Daten
14
System Control
Control de sistema • Utilisation • Systemeinstellungen