Filter
Top Products
SPECIFICATIONS (all models):
BP30
(Head)
11”H x 22”W x 12”D 38 Lbs
BP30-112 20 ½”H x 22”W x 12”D 53 Lbs
BP30-212 20 ½”H x 27”W x 12”D 68 Lbs
BP30-310 25 ½”H x 27”W x 12”D 80 Lbs
TUBE COMPLIMENT
RATED OUTPUT POWER: 30 watts / 15 watts / 8 watts
POWER OPTIONS:
30 watts – 4 tubes / Pentode mode
15 watts – 2 tubes / Pentode mode
15 watts – 4 tubes / Triode mode
8 watts – 2 tubes / Triode mode
POWER CONSUMPTION: 200 WATTS MAXIMUM
CHANGING POWER & PREAMP TUBES: Always use caution when changing tubes. The Power switch
on the amplier should be turned off and the power cable unplugged from the source.
The tubes should be cool. Each tube is secured with a special tube retainer that keeps the tube seated
properly and also helps to counter-act unwanted tube microphonics. A small Phillips screw-driver will be
needed to unscrew the round tube retainer. After this retainer has been removed, rock the tube slightly and
gently while pulling up on the tube and remove it carefully. When re-installing tubes, note that the pin positions
are “keyed” to the socket. Make sure that you seat the tube pins properly in the socket and carefully push it
tight into the socket. Reattach the round tube retainer. Make sure the rubber grommet inside the tube retainer
securely holds down the tube.
NOTE: Dangerous and/or lethal high voltages are present inside the amplier chassis.
Refer all servicing to qualied service persons.