Filter
Top Products
7307400
Operation
Be sure all fluid is thoroughly flushed from the hose
after each use.
Disassemble all other dispensing equipment, as nec-
essary, and clean thoroughly.
CAUTION
To prevent fluid from setting up in the dispensing
equipment, flush the system frequently. Be sure
there is adequate solvent in the solvent supply
before starting to spray.
Dispensing
To dispense the resin and hardener, turn on the supply
pumps. Then push the handle forward (DOWN) to the
open position. To stop the flow, move the handle to the
UP or closed position.
Fig 3 shows the handle in the DOWN, or open, position, sol-
vent valve closed, and resin and hardener flowing through
the manifold.
Solvent
valve
shown
closed
Fig. 3
05766
Handl
e
down
Solvent
Resin
(A)
Hardener
(B)